Konveyör Bant

Konveyör Bant


‘ST’ and ‘ST/MU’ Secondary Scrapers in Tungsten

Long operationg times due to the high resistance to the abrasión of the blades

The scraper blades are designed to work perpendicular to the belt and avoid the accumulation of scraped material on the same.

The model ‘ST/MU’ is suitable to belts with staples unions.

The blades are in tungsten with a high degree of resistance to the abrasion and are assembled to a rubber support by means of two screws, which does that their substitution is fast and simple.

The supports of the scraper blades are specially designed to give flexibility to the blades and absorb any vibration or impact that could be produced.

It assembles by segments of 124 mm. Every segment is an only piece of rubber that assembles easily in the axis of the scraper.

This one is made in wedge shape that produces a flexion on the scraper blades in all the directions.

The set of support and scraper blade, has a protective unbreakable and non stick skirt that protects the set of the accumulation of material in the scraper

The fixation structure of the scraper is a robust piece designed in angle shape and which has a sliding guide to facilitate the positioning of the scraper.

The supports are extensible to can adapt to the structure.



  • Reduce the production cost.
  • Efficient cleaning due to the adaptability of the blades.
  • Avoid accumulation of material due to the nonstick protector.
  • Long operationg times due to the high resistance to the abrasión of the blades.
  • Adequate pressure guaranteed in all the belt width due to the design of the rubber supports.
  • Absortion of the vibrations and impacts due to the rubber supports of the blades.
  • Easy installation.
  • Minimum maintenance.
  • Require small installation space.
  • It adapts to the structure dues to the extensible support design.
  • Easy positioning due to the slide of the support.
  • Easy adjustment.


  • For belt width from 400 to 2000mm.
  • Secondary scraper to install in the belt.
  • Suitable to belts with smooth cover.
  • Belt speed <5 m/s.
  • Temperature range: –20º until +120ºC
  • Model ‘ST’ does not use in belts with staples unions.
  • Model ‘ST/MU’ is suitable to belts with staples unions.
  • Available in ATEX version (explosive atmospheras).